Boom Wear Pad Lubrication - JLG G5-18A Service Manual

Boom
4
5
Use shims under the wear pads as required to maintain a
maximum gap of 0.06 in (1,5 mm) (6) between the wear
pad on the front and sides of the boom. The gap at the
rear of the boom should be no more than 0.12 in (3 mm).
Shims are available in four thicknesses, 0.02 in (0,5mm),
0.04 in (1 mm), 0.06 in (1,5mm) and 0.08 in (2,0mm).
6
3-12
3.4.3
After replacing any wear pad(s), or after prolonged
periods of inoperation, light lubrication of the boom wear
surfaces with a factory authorized grease is
recommended to keep the boom wear surfaces
lubricated properly. Light lubrication of the boom wear
surfaces is also recommended when the machine is
stored, to help prevent rusting.
Note: The first shim next to the pad needs to be the one
with holes, instead of the slots.
MY2010
MY2020
MU4080

Boom Wear Pad Lubrication

G5-18A, 2505