JLG G5-18A Service Manual page 156

Hydraulic System
4. Label or otherwise mark the hydraulic hoses in
relation to the steer select manifold. Disconnect and
cap all hoses, fittings, solenoid wire terminal leads,
etc.
5. Remove the capscrews that attach the manifold to
the frame.
6. Remove the steer select manifold with attached steer
select valve from the machine. Wipe up any
hydraulic fluid spillage in, on, near and around the
machine.
b. Steer Select Valve and Manifold Disassembly,
Cleaning, Inspection and Assembly
1. Place the steer select assembly on a suitable work
surface.
2. Separate the steer select valve from the manifold by
removing the capscrews. Discard the old o-rings.
3. Remove the solenoid valves and cartridges from the
steer select housing.
4. Clean all components with a suitable cleaner before
inspection.
5. Inspect the solenoid cartridges for proper operation.
Check by shifting the spool to ensure that it is
functioning properly. Check that the spring is intact.
Inspect the cartridge interior for contamination.
6. Inspect internal passageways of the steer select
manifold and valve for wear, damage, etc. If inner
surfaces of the manifold DO NOT display an ultra-
smooth, polished finish, or components are
damaged in any way, replace the manifold or
appropriate part. Often, dirty hydraulic fluid causes
failure of internal seals and damage to the polished
surfaces within the unit
Note: ALWAYS replace seals, o-rings, gaskets, etc.,
with new parts to help ensure proper sealing and
operation. Lubricate seals and o-rings with clean
hydraulic oil.
7. Install the solenoid valves and cartridges in the steer
select housing.
8. Attach the steer select valve to the manifold using
new, oiled o-rings and socket head capscrews.
8-20
c. Steer Select Manifold and Valve Installation
1. Attach the steer select manifold and valve to the
mounting plate on the frame using the socket head
capscrews.
2. Connect the hydraulic hoses, fittings, solenoid wire
terminal leads, etc., to the steer select valve and
manifold.
3. Check the routing of all hoses, wiring and tubing for
sharp bends or interference with any rotating
members, and install tie wraps and/or protective
conduit as required. Tighten all tube and hose clamps.
MY2180
4. Start the engine and run at approximately 1/3-1/2
throttle for about one minute, without moving the
machine or operating any hydraulic functions.
5. Inspect for leaks and check the level of the hydraulic
fluid in the reservoir. Shut the engine OFF.
Note: Check for leaks and repair as required before
continuing. Add hydraulic fluid to the reservoir as needed.
6. Wipe up any hydraulic fluid spillage in, on, near and
around the machine, work area and tools.
7. Close and secure the engine cover.
d. Steering Test
1. Conduct a pressure check of the steering hydraulic
circuit at the test port on the implement pump. Refer
to Section 8.5.5, "Steering Pressure Checking."
2. Check each steering mode for proper function.
G5-18A, 2505