Safety - Felix printers Tec 4 User Manual

Safety

11 Safety
To safely operate the FELIXprinter, we advise that you keep the following safety recommendations in mind:
1. FELIXprinters are only suitable for professional use.
2. Keep children under the age of 14 out of reach of the FELIXprinter
3. Only use the materials polylactic acid (PLA), Acrylonitrile butadiene styrene (ABS) or Arnitel as printing material.
Consult FELIXprinters if you want to use a different material.
4. Do not use a different power supply than the provided power supply, it can be dangerous and cause
electronical malfunctions.
5. Always make sure the first layer of the printer is successfully printed, before leaving the printer unattended.
6. When removing or feeding material to the hot end, wearing heat-resistant gloves is recommended.
7. When operating the FELIXprinter, be carefull with long hair and loose clothes.
8. Don't put objects on the heated bed, not even when the printer is turned off.
9. Don't remove any objects from the hot plate while the printer is still printing objects.
10. Turn off the FELIXprinter when errors occur.
11. When unattended, turn off the FELIXprinter.
12. Make sure all moving parts can move without any obstructions.
13. Caution with any moving parts that move in the X, Y and Z direction. At the end of each moving part there is a
pinching hazard.
14. Watch out for any other non-protected sharp edges of the printer.
15. Don't lean on the FELIXprinter when it is operating.
16. Don't transport the FELIXprinter when it is in operation.
17. Only operate the FELIXprinter in a sufficiently ventilated environment (fumes from ABS and PLA can cause
respiratory irritation).
18. Use the FELIXprinter in a dry environment.
19. Use the FELIXprinter on a stable and leveled surface.
20. Place the FELIXprinter on a table/desk/something with a similar height in order to keep small children at a safe
distance.
FELIX Tec 4
User Manual
18 December 2017
www.FELIXprinters.com
15