Malaguti XTM POWER UP 2007 Troubleshooting Manual page 51

B
CHAPTER
4 Setup menu: modify unit of measurement
Access to the setup menu for modifying the unit of
measurement is only possible when the vehicle is
at a standstill. Hold the button down after selecting
the TOD function for about 5 seconds. The headings
'km/h' and 'mph' will appear on the display. The
selected option will be initially flashing. Give the
MODE button a short press to modify the selection.
Give the button a longer press to save the selected
unit of measurement and return the instrument board
to its normal operating condition.
- Changing the unit of measurement will
irreversibly delete the TD and AVE settings.
- The unit of measurement is saved in a
permanent memory.
- If the adjustment menu is opened but no
changes are made within 20 seconds, the
system will automatically switch back to its
normal operating mode and will not save the
selected unit of measurement.
- If the adjustment menu is opened and you
turn the key switch off and on, the system
will be automatically switched back to its
normal operating mode and the selected unit
of measurement will not be saved.
- If the adjustment menu is opened and you
start the engine (speed >0), the system will
be automatically switched back to its normal
operating mode and the selected unit of
measurement will not be saved.
5 Choosing the model
Every time the battery or its fuse is disconnected,
the instrument board will ask the user to enter the
model (Enduro or Motard); this selection is made
by pressing the button in correspondence with the
requested selection during execution of the main
menu.
52
PAGE
SECTION 2
B
- TROUBLESHOOTING
ELECTRIC SYSTEM TROUBLESHOOTING
Signal System
SECTION 2
Adjusting the unit of measurement
Motard selection
Enduro selection
08.06
ISSUE