Removing Models After Printing; Removing The Build Tray From The Printer - Stratasys Objet1000 Plus User Manual

Objet1000 Plus User Guide

Removing Models After Printing

After printing models, you should allow them to cool as much as possible
before handling them. If additional models do not have to be produced on the
printer, it is best to let the printed models cool in the printer, with the cover
closed, as long as possible.
The build tray for the Objet printer is removable, which aids in the handling
Removing the
of printed models. You use a special cart to remove the build tray and transfer
Build Tray
it to the cleaning station.
From the
Printer
To remove the build tray:
1. Press F10.
2. Raise the cart's platform and position the docking guides as shown.
3. Lower the cart platform so that the anchor fits over the docking pin.
4. Pull the build tray onto the cart.
DOC-06810 Rev. B
or—
From the Options menu, select Go to Tray Lower Position.
The print block moves forward and the build tray lowers.
Figure 7-1 Positioning the cart for tray removal
Note: Make sure that the anchor on the platform is raised above the docking
pin on the printer.
Figure 7-2 Securing the cart to the printer
7 Handling Printed Models
7-2