Cisco RV215W Administration Manual page 48

Configuring Networking
Configuring IPv6
STEP 4
STEP 1
STEP 2
STEP 3
Cisco RV215W Wireless-N VPN Firewall Administration Guide
Draft Version 2—Cisco Confidential
IPv6 Address
IPv6 Prefix Length
Default IPv6 Gateway
Static DNS 1
Static DNS 2
Click Save.
Configuring PPPoE IPv6 Settings
If you choose this option, your IPv6 WAN PPPoE settings must match your IPv4
WAN PPPoE settings. See
To configure the PPPoE IPv6 settings:
Choose Networking > IPv6 > IPv6 WAN Configuration.
In the WAN Connection Type field, choose PPPoE IPv6.
Enter the following information (you may need to contact your ISP to obtain your
PPPoE login information):
Username
Password
Enter the IPv6 address of the WAN port.
Enter the IPv6 prefix length defined by the ISP.
The IPv6 network (subnet) is identified by the initial
bits of the address which are called the prefix.
For example, in the 2001:0DB8:AC10:FE01::
IP address, 2001 is the prefix.
All hosts in the network have identical initial bits for
their IPv6 address; you set the number of common
initial bits in the network addresses in this field.
Enter the IPv6 address of the default gateway. This
is the IP address of the server at the ISP that this
router connects to for accessing the Internet.
Enter the IP address of the primary DNS server on
the ISP IPv6 network.
Enter the IP address of the secondary DNS server
on the ISP IPv6 network.
Configuring PPPoE.
Enter your username assigned to you by the ISP.
Enter your password assigned to you by the ISP.
2
42