Configuring Dhcp - Cisco RV215W Administration Manual

Configuring Networking
Configuring the LAN Settings
STEP 3
STEP 1
STEP 2
STEP 3
Cisco RV215W Wireless-N VPN Firewall Administration Guide
Draft Version 2—Cisco Confidential
Click Save.
After changing the IP address, your PC is no longer able to display the
.
Manager
To display the
Device Manager
• If DHCP is configured on the , release and renew your PC IP address.
• Manually assign an IP address to your PC. The address must be on the same
subnetwork as the . For example, if you change the IP address to 10.0.0. 1 ,
assign your PC an IP address in the range of 10.0.0.2 to 10.0.0.255.
Open a new browser window and enter the new IP address of the to reconnect.

Configuring DHCP

By default, the functions as a DHCP server to the hosts on the Wireless LAN
(WLAN) or wired LAN. It assigns IP addresses, and provides DNS server
addresses.
With DHCP enabled, the assigns IP addresses to network devices on the LAN
from a pool of IPv4 addresses. The tests each address before it is assigned to
avoid duplicate addresses on the LAN.
The IP address pool (192. 1 68. 1 . 1 00 to 192. 1 68. 1 . 1 49). If you need to set a static IP
address on a network device, use an IP address outside the pool. For example
assuming the DHCP pool is set to the default parameters, static IP addresses from
192. 1 68. 1 .2 to 192. 1 68. 1 .99 IP address pool can be used. This prevents conflicts
with the DHCP IP address pool.
To configure DHCP settings:
Choose Networking > LAN > LAN Configuration.
(Optional) Select a VLAN to edit from the drop-down list.
In the DHCP Server field, select one of the following options:
Enable Allows the to act as the DHCP server in the network.
Disable Disables DHCP on the when you want to manually configure
the IP addresses of all of your network devices.
, do one of the following:
2
Device
27