Setting The Automatic Truck Cutout - Jungheinrich EJE C20 Operating Instructions Manual

Requirements
Procedure
When you enter the correct master code the LED
(75) flashes green.
Wait until the LED (75) flashes green.
Wait until the LED (75) flashes green. The setting is saved.
The truck is switched off and the LED (75) lights up red.
When you have entered a valid operator code the LED (75) lights up green, the
travel program selected is indicated by the corresponding LEDs (71,72,73) and
the truck is switched on.
The truck is switched off and the LED (75) lights up red.