Change Operator Code - Jungheinrich EJE C20 Operating Instructions Manual

Requirements
Procedure
When you enter the valid master code the LED (75)
flashes green.
The LEDs (71,75) flash green.
The LEDs (72,75) flash green.
Z
The LEDs (73,75) flash green.
Wait until the LED (75) flashes green. The setting is saved.
The truck is switched off and the LED (75) is lit red.
After entering the valid user code the LED (75) lights up green, the travel
program setting is shown by the illumination of the corresponding LEDs
(71,72,73) and the truck is switched on.
The truck is switched off and the LED (75) is lit red.