Adapting The Travel Program Configuration To The User Code - Jungheinrich EJE C20 Operating Instructions Manual

Adapting the travel program configuration to the
user code
Procedure
When you enter the valid master code the green
LED (75) flashes green.
The LEDs (71,75) flash green.
The LEDs (72,75) flash green.
The LEDs (73,75) flash green.
Wait until the LED (75) flashes green. The travel programs are now assigned to the
user code.
The truck is switched off and the LED (75) is lit red.
After entering the valid user code the LED (75) lights up green, the travel
program setting is shown by the illumination of the corresponding LEDs
(71,72,73) and the truck is switched on.
The truck is switched off and the LED (75) is lit red.