Binding Of Radio Transmitter And Receiver - ProFlight PFBD103 User Manual

Binding of Radio Transmitter & Receiver
1. Place the drone upside down on a flat surface and turn it on using the
small switch on the underside next to the charging port, which will start
the lights flashing. Then turn the drone over, so it is stood on its feet.
2. Turn on the controller.
3. The controller will beep
twice, and the red LED
will flash. Pair it to the
drone by pushing the
throttle stick to the top,
it will bleep, and then
pull the throttle stick to
the bottom.
4. The long bleep indicates it is paired.
5. The Gyro should then be calibrated, by
holding both joysticks diagonally down to the
right, until the lights on the drone stop
flashing.
6. Once this has been done you are ready to fly the drone, press the left
joystick up to take off.
7 of 12