Cisco IAD2801 Series Installation Manual page 69

Appendix B Installing and Upgrading Internal Modules
Figure B-1 Removing the Cisco IAD2801 Chassis Screws
Insert a flat-blade screwdriver between the chassis and chassis cover at the screwdriver pry points on the
Step 3
bottom of the chassis, indicated in
chassis cover from the chassis. It may be necessary to turn the unit upside down on a flat surface to
access the pry points.
Figure B-2
Gently slide the chassis cover of the router away from the bottom of the chassis, as shown in
Step 4
OL-12433-01
Figure B-2. Rotate the screwdriver 90 degrees to disengage the
Screwdriver Pry Points
1
Cisco IAD2801 Series Integrated Access Devices Hardware Installation Guide
Removing the Chassis Cover
1
Figure B-3.
B-3