Installing An Mx240 As Msc; Figure 147: Removing An As Msc - Juniper MX240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide

Installing an MX240 AS MSC

330

Figure 147: Removing an AS MSC

To install an AS MSC (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Align the notches in the connector at the rear of the AS MSC with the notches in the
2.
AS MSC slot (slot —the top slot in the AS MLC ), and then slide the AS MSC in until
0
it lodges firmly in the AS MLC.
CAUTION: Slide the AS MSC straight into the slot to avoid damaging the
components on the bottom of the AS MSC.
Use one of the following methods to bring the AS MSC online:
3.
Press the AS MSC offline/online button until the LED light turns green.
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the
Figure 102 on page 252):
.
CLI Explorer
Copyright © 2017, Juniper Networks, Inc.