Table of Contents
Advertisement
Installing the Cabinet
2b
1
1
Determine the installation position of the
cabinet.
Determine the position for installing the cabinet
based on the engineering drawing. Mark the four
corners of the cabinet
Use the powder marker to draw the outline of the
cabinet.
1
3
Secure the cabinet in place.
Open the front and rear doors.
Rotate the four leveling feet clockwise by using a
Phillips screwdriver to lower the leveling feet.
Rotate the M12 bolts at the bottom of the leveling
feet clockwise by using an adjustable wrench until
the leveling feet contact the ground and the wheels
hang in the air.
Ensure that the heights measured from the front,
rear, right, and left of the cabinet are the same.
Spin the wheels by using a Phillips screwdriver. If the
wheels rotate freely, they are hanging in the air.
H indicates the distance from the cabinet top to the
ground. The cabinet height can be adjusted from 1195
mm to 1205 mm with the help of the leveling feet.
1
2
Place the cabinet in place.
Move the cabinet in place.
Align the cabinet edges with the marks on the floor
using a right square.
1
4
Level the cabinet.
Use a level and plumb line to measure the cabinet.
Ensure that the cabinet is level.
If the cabinet is not level, use an adjustable wrench to
raise or lower the leveling feet.
Measure the front and rear doors of the cabinet as
follows:
Place the level along the surface of the cabinet. If
the air bubble goes to the center of the clear tube,
the surface is even.
31
Advertisement
Table of Contents
