Table of Contents
Advertisement
Installing the industrial connector
(This operation must be performed by professional electricians onsite.)
Loosen component 1 and screw A, remove
component 3, and loosen screw B.
Component 1
Component 2
Remove screw C, insert the live wire (brown),
neutral line (blue), and ground cables (yellow
and green) into the screw-type terminals that
are labeled L, N, and
fasten screw C.
5
Connect the industrial connector to the industrial socket until the industrial connector is firmly
seated in the slot at the middle of the industrial socket (at the position of D as shown in the figure
on the right).
Component 3
respectively, and
46
Pass the cable through component 1 and
component 2 to the pressing sheet of
component 3 (at the position of screw B).
Fasten screw B to secure the cables, fix
component 3 into component 2, and fasten
screw A and component 1.
B
Advertisement
Table of Contents
