Configuring A Port - Advantech PCI-1602UP User Manual

4.4.2

Configuring a Port

You can choose to configure a specific port (or to configure all ports) before running
your test. Just click a Com Port Tab to select the port you want to configure, and then
click the Port Setup
to configure all ports at once, just click the All Ports Setup
All Ports/Setup menu command) to bring up the Configure Port dialog box such as
below.
Figure 4.5 Test Information on the Performance Listing Area
In the Configure Port dialog box, you can configure the Baud Rate, Data bits, Parity,
Stop Bits and the flow control mode for that specific port (or for all ports). After you
have configured all the settings you want to change, click OK to make this configura-
tion active.
Note!
When using All Ports Setup button or All Ports/ Setup
mand to configure settings for all ports, you must take care to stop any
ports
that are running test in order to configure them. If you do not stop the
test running on a specific port, it won't be configured at all. That is, you
get to configure only the ports that have been stopped.
Run the Test
After you have completed the configuration of the port(s), you can now start the test
on the port you have selected by clicking the Run
Run menu command (or you want to run all ports at once, just click the All Ports
Run button or access All Ports/Run menu command).
Once the test is started, you can see relevant test information of port performance on
the performance listing area.
PCI/ PCI Express-Communication User Manual
button or use the Port/Setup menu command (or if you want
36
button or access the
menu com-
button or accessing the Port/