Mode Selection By Jumper/Dip Settings; Figure 2.14Pci-1603 Default Settings - Advantech PCI-1602UP User Manual

2.3.2.1 PCI-1603
The board will be shipped in the RS-232 mode, passive Rx and active Tx. On the
10*2 pin jumper groups (JP2 & JP4)— A, B, C, D and E are set to RS-232 transmis-
sion mode. On the 6*2 pin jumper groups (JP3 & JP5)—C, D and E are set to passive
Rx and active Tx. They are the card default settings.
2.3.3

Mode Selection by Jumper/DIP Settings

2.3.3.1 RS-232/422/485 Selection (for PCI-1612A/B/C)
(RS-232 Selection compatible for PCI-1610A/B/C)
Should you wish to configure the PCI-1612A/B/C to operate in the RS-232 mode, the
bottom two pins of the 12*3 pin jumper should be connected. For RS-422/ RS-485
mode selection, the upper two pins of the 12*3 pin jumper should be connected, and
two pins of the 13th pin jumper should be connected for only PCI-1612A/B cases, as
shown below.
Figure 2.15 PCI-1612 Series RS-232/422/485 Selection
PCI/ PCI Express-Communication User Manual
Figure 2.14 PCI-1603 Default Settings
18