Lfo - Elektron Digitone User Manual

11. SYNTH TRACK PARAMETERS
11.9.1 CHR
Chorus Send sets the amount of sound sent through to the Chorus effect. For more information, please
see "13. FX PARAMETERS" on page 53. (OFF, 0.01–127.00)
11.9.2 DEL
Delay Send sets the amount of sound sent through to the Delay effect. For more information, please see
"13. FX PARAMETERS" on page 53. (OFF, 0.01–127.00)
11.9.3 REV
Reverb Send sets the amount of sound sent through to the Reverb effect. For more information, please
see "13. FX PARAMETERS" on page 53. (OFF, 0.01–127.00)
11.9.4 AENR
Amp envelope reset sets the amp envelope behavior:
ON resets the envelopes for each consecutive trig (default).
OFF does not reset the envelopes for each consecutive trig. It instead lets the envelope cycle complete.
11.10 LFO PAGE 1
The two Low-Frequency Oscillators can be used to modulate the parameters found on the synth tracks
SYN1, SYN2, FILTER and AMP pages. Customize the low-frequency oscillators destination, wave, speed,
and depth on this page.
Press [LFO] to access this parameter page.
11.10.1 DEST1
Destination selects the modulation destination for the LFO1. Preview how the LFO modulation affects the
sound by highlighting a destination. Press [YES] to confirm the selection.
11.10.2 WAVE1
Waveform sets the LFO1 waveform. There are seven waveforms: Triangle, Sine, Square, Sawtooth, Expo-
nential, Ramp, and Random.
11.10.3 SPD1
Speed sets the speed of the LFO1. Try settings of 8, 16 or 32 to sync the LFO to straight beats. The knob
is bipolar. The LFO cycle can be played backward by using negative values. (-64.00–63.00)
11.10.4 DEP1
Depth sets the depth and polarity of the LFO1 modulation. Both negative (inverted) and positive modula-
tion depth is possible. A center setting, 0.00, equals no modulation depth. (-64.00–63.00)
11.10.5 DEST2
Same as DEST1 but for LFO2.
46