7.3.3 MEASUREMENTS
Select this menu item to find the following measurements in this order:
Power Usage Efficiency
Output
(active and apparent power)
Output
(current and power factor)
Output
(voltage and frequency)
Input
(voltage and frequency)
Battery
(voltage and charge state)
DC bus
(intermediate circuit voltage)
External battery modules
Total kWh consumption
If you want to see any particular measurement on the screen
permanently, you can "freeze" the screen in the Measurements menu.
To do so, press "▲" and "▼" for approx. 3 seconds at the same time
until a small key appears in the upper right-hand corner of the display.
Press the two buttons again at the same time for approx. 3 seconds to
cancel this setting control.
7.3.4 CONTROL
During normal mode, you can active this menu item to access
the following sub-menu items: "Go to bypass", "Battery test" and
"Reset error state".
Depending on the operating mode, only those sub-menu items that are
available will appear.
[%]
[W] & [VA]
[A]
[V] & [Hz]
[V] & [Hz]
[V] & [%]
[V]
[kWh]
39