Measurements; Control - AEG Protect D Series User Manual

6.2.2

Measurements

Select this menu item to find the following measurements in this order:
Power Usage Efficiency
Output power
(active and apparent power)
Output power
(current and power factor)
Output
(voltage and frequency)
Input
(voltage and frequency)
Battery
(voltage and charge state)
DC bus
(intermediate circuit voltage)
External battery modules
Total kWh consumption
If you want to see any particular measurement on the screen
permanently, you can "freeze" the screen in the Measurements menu. To
do so, press "◄" and "►" for approx. 3 seconds at the same time until a
small key appears in the upper right-hand corner of the display. Press the
two buttons again at the same time for approx. 3 seconds to cancel this
setting.
6.2.3

Control

During normal mode, you can active this menu item to access the
following sub-menu items: "Go to bypass mode", "Battery test", "Reset
error state" and "Load segments".
Depending on the operating mode, only those sub- menu items that are
available will appear.
"Control" / Command
Go to
Bypass / Normal
[%]
[W] & [VA]
[A]
[V] & [Hz]
[V] & [Hz]
[V] & [%]
[V]
[kWh]
Description
Possibility to change operation
mode.
If the UPS is not in Normal Mode
or Bypass Mode this option is not
31
EN