AEG Protect C.1000 Operating Instructions Manual page 25

Mains connection (UPS input)
1.
2. Mains input circuit breaker
3. Monitored fan(s) with intelligent speed control (Attention: At least
100mm of free space is required behind the fan for free ventilation!)
4. Communication interface RS232
(9-pin SUB-D socket)
5. USB communication port
6. Emergency Power Off,
optionally to be configured as opener or closer
7. Communication slot for optional expansion cards: relay card,
remote ON/OFF, SNMP, ...
The USB and the RS232 communication interfaces rule each other
out, i.e. either USB or RS232. The communication slot, on the other
hand, is dual-monitor enabled, i.e. can be used parallel to the USB
or RS232 interface.
8. Connection for external battery module
9. Consumer connectors (UPS output)
IEC 320 C13 (10 A)
10. Separate protection of load circuits for
PROTECT C.3000
11. Consumer connection PROTECT C.3000 (UPS output)
IEC 320 C19 (16 A)
12. Consumer connection PROTECT C.3000 (UPS output)
via terminal block
25