Table of Contents
Advertisement
9.10.2 Wiring Guidelines
Before installing cables between the cradle and other devices, review the following:
•
Ensure that drilling holes will not damage the vehicle or its wiring.
•
Protect cable runs from pinching, overheating and physical damage.
•
Use grommets to protect cables that pass through metal.
•
Use plastic straps and tie-downs to secure cables and connectors in their
desired location, away from areas where they may get snagged or pulled.
•
Keep cables away from heat sources, grease, battery acid and other
potential hazards.
•
Keep cables away from control pedals and other moving parts that may
damage the cables or interfere with the operation of the vehicle.
9.10.3 Using The Vehicle Cradle
If your WORKABOUT PRO is equipped with a shoulder strap or cover, these
accessories need to be removed before installing the unit in a vehicle cradle. There is
no need to remove handstraps, pistol grips or tethered devices from the unit.
•
Slide the WORKABOUT PRO into the cradle, and press firmly downward
until it locks into place. On a vehicle, it's a good idea to pull up on the
WORKABOUT PRO to be certain that it is secure.
•
To remove the unit, press firmly on the RELEASE button on the front face
of the unit until it releases from it latch. The hand-held will be slightly
raised so that it can be removed.
9.10.4 Maintaining The Vehicle Cradle
Two latches in the cradle hold the WORKABOUT PRO firmly in place. Although
these latches are designed for robustness and endurance, they will wear over time
and will no longer lock the hand-held securely in the cradle. For replacement parts
and instructions contact Psion Teklogix. Partial disassembly is required.
9.10.5 Powered Cradle Installation In High Voltage Vehicles
Warning:
Voltages exceeding 60VDC are considered hazardous. For powered
cradle installations on vehicles with batteries above this voltage,
ensure the powered cradle power connector is mounted in a dry
location on the vehicle, or that the connector is insulated with an
appropriate waterproof material after installation. The connector
WORKABOUT PRO Hand-Held Computer With Windows Mobile 5.0 User Manual
Chapter 9: Peripheral Devices & Accessories
Wiring Guidelines
323
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
