Gobos & Gobo Replacement - ADJ FOCUS SPOT 5Z User Manual

G O B O S & G O B O R E P L A C E M E N T
The gobo's featured in this unit are interchangeable. Remember when changing these gobo's that they
are thin and easy to bend.
If removing/replacing the glass gobo, please be very careful. Keep in mind that this is a glass gobo,
which means it is delicate. Please take care when removing/replacing any of the gobos.
Caution! Never open the unit when in use. Always disconnect the main power before attempting to
change the gobos.
Locating the Gobo wheel: After disconnecting the main power, position the head with the lens facing
forward. When looking through the front lens, position the head so that the frost filters are located
at the top (see image below). When the frost filters are located at the top, the shell that needs to be
unscrewed and removed is now facing up.
1. To change a gobo, uscrew the 4 screws that secure the shell to
the unit. Gently lift and remove the shell.
2. Once the shell is removed, you will be able to access the gobo
wheel. Turn the wheel until you come across the gobo you
would like to change.
3. Once you have found the gobo you would like to change, use
your finger to carefully turn the small inner gear so that the
"alignment dot" on the inner gear, lines up with the gobo you
would like to replace.
4. Once the gobo and "alignment dot" are lined up, CAREFULLY,
from underneath the gobo wheel, push the gobo housing with
gobo up and pull the housing out.
5. CAUTION! Do not put to much pressure on the gobo itself due
to the fact it is thin and it can bend.
6. Using your fingernail or needle nose pliers, CAREFULLY
remove the retainer ring that secures the gobo in place. After
the retainer ring is removed, your are able to remove the gobo.
13