Gold's Gym XR45 User Manual page 19

29. Note: For clarity, the Shrouds are not shown
in this step.
Thread an M12 Nut (84) as far as possible onto
the High Cable (55). Then, place a Large Washer
(85) on top of the Weight Tube (24).
Tighten the High Cable (55) into the Weight Tube
(24) until all the slack is removed from the cables.
Then, tighten the M12 Nut (84) against the Large
Washer (85).
Seat Assembly
30. Attach the Backrest (16) to the Lower Upright (93)
and the Upper Upright (3) with two M6 x 63mm
Screws (70) and two M6 Washers (82).
31. Attach the Seat (15) to the Seat Frame (6) with
four M6 x 16mm Screws (62) as shown.
29
30
16
31
15
Wide
End
6
19
55
84
85
24
3
70
82
93
70
82
62