Gold's Gym XR45 User Manual page 17

23. Attach the Low Cable (53) to the "U"-bracket (45)
with an M8 Washer (59) and an M8 Locknut (58).
See the inset drawing. Do not overtighten the
M8 Locknut (58); it should be threaded onto
the end of the Low Cable (53) so that only two
threads are showing above the Locknut.
24. See the CABLE DIAGRAM on page 25 and
identify the High Cable (55).
Route the HIgh Cable (55) up through the Top
Frame (4) and over a 90mm Pulley (48).
Attach the 90mm Pulley (48) inside the Top
Frame with an M10 x 67mm Bolt (71), two M10
Washers (57), two 12mm Spacers (52), and an
M10 Locknut (56).
25. Route the High Cable (55) over a 90mm Thin
Pulley (47) and down through the Top Frame (4).
Attach the 90mm Thin Pulley (47) inside the Top
Frame (4) with an M10 x 67mm Bolt (71), an M10
Washer (57), and an 11mm Spacer (49). Make
sure that the Thin Pulley does not fall out of
the Top Frame while you complete steps 26
and 27.
23
58
59
58
45
53
24
56
57
52
25
17
45
53
55
4
48
57
71
52
47
4
55
49 57
71