Advertisement
3. Place the workpiece on the saw table with the hole in the
workpiece over the access hole in the table.
4. Install a blade through the
hole in the workpiece.
5. Follow steps 3-7, under
Freehand cutting.
6. When finished making the
interior scroll cuts simply
turn the scroll saw OFF.
Unplug the saw before
removing the blade from
the blade holder. Remove
the workpiece from the
table.
Rip or straight line cutting (Fig. 24)
1. Raise the blade guard foot (1) by loosening the height
adjustment knob (2).
2. Measure from the tip of the
blade to the desired distance.
Position the straight edge
parallel to the blade at that
distance.
3. Clamp the straight edge to
the table.
4. Recheck your
measurements using the
workpiece to be cut and
make sure the straight edge
is secure.
5. Position the workpiece against the blade and place the
blade guard foot against the top surface of the workpiece.
6. Secure the blade guard foot in place by tightening the
height adjustment knob.
7. Remove the workpiece from the blade prior to turning the
scroll saw ON.
CAUTION: In order to avoid uncontrollable lifting of the
workpiece and reduce blade breakage, do not turn the switch on
while the workpiece is against the blade.
2
Fig. 23
Fig. 24
1
Advertisement
