Advertisement
Blade guard foot adjustment
When cutting at angles, the blade guard foot should be adjusted
so it is parallel to the table and rests flat above the workpiece.
1. To adjust, loosen the screw (2) , tilt
the foot (1) so it is parallel to the
table, and tighten the screw.
2. Loosen the height adjustment knob
(3) to raise or lower the foot until it
just rests on top of the workpiece.
Tighten the knob.
3. Loosen the horizontal adjustment
knob (4) and move the foot forward
or backward as needed.
Attach the rotary tool table (Fig. 7 and 8)
1. Secure the rotary tool table (1) to
the side of the saw using the four
hex head screws (2) and washers
provided with the table.
2. Place the rotary table insert (3) in
the opening on the rotary table.
Note: The rotary tool (4) attaches to the
clamp located below the rotary tool table.
Sawdust collection port (Fig. 9 and 10)
This scroll saw allows a hose or vacuum
accessory (not provided) to be
connected to the dust chute (1) at the
front of the saw and to the dust chute (2)
under the rotary tool table(3), if
installed.
If excessive sawdust buildup occurs
inside the base, use a wet/dry vacuum
cleaner or manually remove saw dust. This will keep your saw
cutting efficiently.
3
4
Fig. 7
4
Fig. 8
Fig. 9
1
Fig. 6
2
1
1
2
3
Advertisement
