Advertisement
CAUTION: In order to avoid uncontrollable lifting of the
workpiece and to reduce blade breakage, do not turn the
switch on while the workpiece is against the blade.
6. Slowly feed the workpiece into the blade by guiding and
pressing the workpiece down against the table.
CAUTION: Do not force the leading edge of the workpiece
into the blade. The blade will deflect, reducing accuracy of cut,
and may break.
7. When the cut is complete, move the trailing edge of the
workpiece beyond the blade guard foot. Turn the switch
OFF.
Angle cutting (bevel cutting) (Fig. 22)
1. Layout or secure design
to workpiece.
2. Move the blade guard
foot to the highest
position by loosening the
height adjustment knob.
Retighten.
3. Tilt the table to the
desired angle by
loosening the table bevel
lock (1) and turning the
bevel adjustment knob
(2)to move the table to
the proper angle using the degree scale and the pointer
(3).
4. Tighten the table bevel lock (1).
5. Loosen the blade guard screw, and tilt the blade guard to
the same angle as the table. Retighten the blade guard
screw.
6. Position the workpiece on the right side of the blade.
Lower the blade guard foot against the surface by
loosening the height adjustment knob. Retighten.
7. Follow steps 5-7 under Freehand cutting.
Interior cutting (Fig. 23)
1. Lay out the design on the workpiece. Drill a 1/4" hole in
the workpiece.
2. Remove the blade. See Blade removal and installation.
Fig. 22
2
3
1
Advertisement
