Table of Contents
Advertisement
Fuses
F3
F4
F5
F6
Note: Fuses F4 and F5 are only applicable to FF units. F6 only for option Phase Sequence Relay. See also
section Electric diagrams.
To modify the terminal bridge configuration to the motor, configure the terminal bridges for the desired voltage
(208 V, 230 V or 460 V) according to the diagram below. The terminal bridges (1) can be easily removed
using a pair of pliers. Additional terminal bridges are provided with the compressor. The connections for 230
V are the factory standard.
Locate the yellow voltage labels provided with the compressor. Replace the existing label with the appropriate
voltage label (200 - 208 V, 230 V or 460 V).
Compressor status indication on compressors equipped with an Elektronikon® controller
The Elektronikon regulator is provided with an auxiliary relay (K05) for remote indication of a shutdown.
Maximum load for the contacts: 10 A / 250 V AC. Stop the compressor and switch off the voltage before
connecting external equipment. Consult Atlas Copco.
Compressor status indication on compressors equipped with an Elektronikon® Graphic controller
The Elektronikon regulator is provided with auxiliary contacts (K05, K07 and K08) for remote indication of:
• manual load/unload or automatic operation (K07)
• warning condition (K08)
• shut-down condition (K05)
Maximum load for the contacts: 10 A / 250 V AC. Stop the compressor and switch off the voltage before
connecting external equipment. Consult Atlas Copco.
130
Fuse rating V
208 V
250 V AC
1 A
600 V AC
15 A
600 V AC
10 A
600 V AC
1 A
230 V
460 V
1 A
1 A
15 A
6 A
10 A
10 A
1 A
1 A
Instruction book
Class
UL class JDYX or JDYX2 5 x 20
mm
UL guide JDDZ class CC type
FNQ-R 10.3 x 38 mm
UL guide JDDZ class CC type
FNQ-R 10.3 x 38 mm
UL guide JDDZ class CC type
FNQ-R 10.3 x 38 mm
2920 7090 51
Advertisement
Table of Contents
