HP server rx4610 Service Manual page 118

Chapter 6
12. Secure the triple beam into place by tightening the top captive screws and then the four
thumbscrews on the end of the beam.
12. If you are installing a CPU thermal dummy, skip this step. Otherwise, connect the Y-cable to
each power pod.
13. Insert the sheet metal baffle at the front of the processors or CPU thermal dummies in the
Processor/Memory Complex. To insert the baffle, press the flexible retaining tabs in as you
slide the baffle into place.
14. Be sure to close the plastic latch to secure the Processor/Memory Complex halves.
15. Insert the Processor/Memory Complex into the chassis.
Figure 41. Placing the Triple Beam Over the Processors
Replacing Parts
110