Removing And Installing The Hard Disk Bay; Removing The Hard Disk Bay; Installing The Hard Disk Bay - HP server rx4610 Service Manual

Chapter 6
25. Once the accessory board is installed, you may need to install software drivers. The drivers for
the new board are either part of your existing system software or included on a flexible diskette
provided with the accessory board.

Removing and Installing the Hard Disk Bay

The Hard Drive Bay provides mounting features for two hot swap hard drives, the Front Panel Interface
board, and the Hot Swap Backplane board. You can easily remove and install the bay from the chassis by
removing the front bezel and four mounting screws.

Removing the Hard Disk Bay

To remove the Hard Disk Bay, complete the following procedure:
1. Turn off the system by using the power on/off switch on the front of the chassis and remove
both AC power cords.
2. Remove the front bezel.
3. Remove each hard disk drive from the drive bay by first grasping its handle and depressing the
drive locking tab, and then sliding the drive out of the bay.
4. Remove the four #2 Phillips screws from the top and bottom of the drive bay.
5. Grasp the bay by the Front Panel display housing and gently pull the drive bay out of the
chassis.

Installing the Hard Disk Bay

To install the Hard Disk Bay, complete the following steps:
1. Turn off the system by using the power on/off switch on the front of the chassis and remove
both AC power cords.
2. If the front bezel is not already removed, remove the bezel.
3. Align the Hard Disk Bay such that the connector side is facing into the chassis and push the bay
into the front of the chassis.
4. Ensure the drive bay seats into the front connector on the Power Distribution Board (T-Docking
Board).
5. Replace the four screws at the top and bottom of the bay.
6. Replace any disk drives into drive bay as required.
Figure 32. Hard Disk Bay
Replacing Parts
98