Installing Memory Boards - HP server rx4610 Service Manual

Chapter 6

Installing Memory Boards

Two memory boards exist, one plugged into each side of the Processor Baseboard (the top and the
underside of the Processor/Memory Complex). This procedure describes the installation process for either
memory board. To re-install the memory board or install a new board, complete the following procedure:
1. Observe all safety and ESD precautions.
2. Remove the Processor/Memory Complex.
3. With both extraction levers raised to engage the guide pins, place the memory board over the
Processor Baseboard connector and guide pins
4. Engage both guide pins at the same time. Ensure that the memory board remains parallel to
the Processor Baseboard.
NOTE
5. Slowly depress the levers until the Memory Board connector fully engages.
6. Tighten the two captive screws that secure the extraction handle assembly.
7. Place the two board clamps along the sides of the memory board such that the screws align
with their respective holes.
8. Secure the two board clamps with the two board clamp screws.
9. Place the bracket with the thumbscrew that locks the extraction lever over the extraction levers
and tighten the screw.
Figure 42. Memory Boards
Both extraction levers must be depressed evenly while inserting the Memory Board.
The Memory Board must remain parallel to the Processor Baseboard during
insertion.
Replacing Parts
112