Install the hard drive.
4.
Installing a four-bay hard drive cage
To install the component:
Power down the server (on page 20).
1.
Remove the server from the rack (on page 20).
2.
Remove the primary access panel (on page 21).
3.
Remove the secondary access panel (on page 21).
4.
Disconnect the front panel LED cable and the front USB cable.
5.
Disconnect the hard drive cables from the system board.
6.
Disconnect cables from any other devices installed in the hard drive cage, if necessary.
7.
Remove all hard drives
8.
("Removing a hard
drive" on page 32).
Hardware options installation 34