Minolta Di200 Service Manual page 44

FrameMaker Ver.5.5E(PC) Di200/Di251/Di351 DIS/REASSEMBLY, ADJUSTMENT
01.02.09
4011D068AB
4011D069AA
4011D066AA
4011D070AB
4011D071AB
6. Remove the harness from the Rear Cover.
7. Remove two screws and the Rear Cover.
8. Remove one screw and the lamp holder in the
rear.
9. Remove one screw and the lamp holder at the
front. Then, slide out the Fusing Roller Heater
Lamp.
10. Remove the harness from the harness guide and
edge cover.
11. Remove one screw, one shoulder screw, and the
Paper Exit Cover Assy.
12. Remove three screws, Coupling Gear Assy, and
gear.
13. Remove three screws and the Drive Frame Assy.
14. Unhook the spring to free the Rear Pressure
Lever Assy.
15. Remove two screws and the Lever Assy.
16. Unhook the spring to free the Front Pressure
Lever Assy.
17. Snap off one retaining ring E type and remove
the idle lever.
D-29