Start Up - Thermo Scientific Precision GP 02 User Manual

Chapter 4
| Operation
CAUTION
4-2
| Precision

Start Up

Before starting, double check all electrical connections.
Do not run the bath until fluid is added to the reservoir. Have extra fluid on hand. If the bath does
not start refer to Chapter 6 Troubleshooting.
Place the circuit protector located on the rear of the bath to the I position.
•
• The screen will momentarily display
the set point and the audible alarm status. The set point is the desired reservoir fluid temperature.
• Press to start the bath and display the reservoir fluid temperature. If the fluid
temperature is below the set point the heater will start.
29.9°C
30.0°C
and then the home screen appears displaying
30.0°C
Thermo Scientific