Thermo Scientific Precision GP 02 User Manual page 44

Thermo Scientific
General Purpose Water Bath Specifications
Reservoir Fluid Control
Temperature °C
°F
Set Point Temperature
Range°C
°F
Ambient Temperature °C
Range °F
Stability @ 37°C
Uniformity @ 37°C
Heating Output watts
Bath Volume liters
Overall Bath Dimensions
(L x W x H) cm
inches
Bath Work Area
Dimensions
(L x W x H) cm
inches
Approximate Weight kg
lb
Electrical
Requirements (VAC/Hz)
(Voltage ±10%)
Compliance
Maximum Relative
Humidity
(Non Condensing)
Operating Altitude meters
feet
Overvoltage Category
Pollution Degree
Storage Temperature °C
Range °F
Low-end reservoir fluid control temperatures require supplemental cooling.
Specifications obtained at sea level using water.
Thermal beads may be used instead of water but they will degrade the bath's uniformity and stability.
Bath depth includes bezel, height does not include lid.
Thermo Fisher Scientific takes no responsibility for damages caused by the selection of an unapproved fluids.
Thermo Fisher Scientific reserves the right to change specifications without notice.
GP 20
Ambient to 100
Ambient to 212
1200
20
39.2 x 55.5 x 23.3 39.2 x 55.5 x 28.2
15.4 x 21.8 x 9.2 15.4 x 21.8 x 11.1
29.7 x 50.0 x 15.0 29.7 x 50.0 x 20.0
11.7 x 19.7 x 5.9 11.7 x 19.7 x 7.9
10
22
100-115/50-60
200-230/50-60
CE
UL
80% for temperatures up to 31°C (88°F)
decreasing linearly to 50% relative humidity at 40°C (104°F)
Sea Level to 2000
Sea Level to 6560
-13 to +140
General Information
GP 28 GP 15D
+5 to 100
+9 to 212
+15 to 45
+59 to 113
±0.1
±0.2
1200 300 and 800
28 5 and 10
39.2 x 58.7 x 23.3
15.4 x 23.1 x 9.2
See GP 05 and GP 10
12
26
or
RoHS
WEEE
II
2
-25 to +60
Chapter 2
|
TBD
TBD
2-3
Precision |