Table of Contents
Advertisement
OEM / Reseller Marking and Documentation Requirements
FCC
The Original Equipment Manufacturer (OEM) must ensure that FCC labelling requirements are met. This includes a
clearly visible label on the outside of the final product enclosure that displays the contents as shown:
Contains FCC ID:VHARAD24
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may cause undesired operation.
The T24-SAe device has been tested with T24-ANTA and T24-ANTB. When integrated in OEM products, fixed
antennas require installation preventing end-users from replacing them with non-approved antennas. Antennas
other than T24-ANTA and T24-ANTB must be tested to comply with FCC Section 15.203 (unique antenna
connectors) and Section 15.247 (emissions).
T24-SAi and T24-Sae modules have been certified by the FCC for use with other products without any further
certification (as per FCC section 2.1091). Changes or modifications not expressly approved by Mantracourt could
void the user's authority to operate the equipment.
In order to fulfil the certification requirements, the OEM must comply with FCC regulations:
1. The system integrator must ensure that the text on the external label provided with this device is placed on
the outside of the final product.
2. The T24-Sae module may be used only with Approved Antennas that have been tested by Mantracourt.
IC
Labelling requirements for Industry Canada are similar to those of the FCC. A clearly visible label on the outside
of the final product enclosure must display the following text:
Contains Model RAD24 Radio (2.4 GHz), IC:7224A-RAD24
Integrator is responsible for its product to comply with RSS-210 - Low-power Licence-exempt Radio
communication Devices (All Frequency Bands): Category I Equipment RSS.
CE
The T24 series has been certified for several European countries.
If the T24-SA is incorporated into a product, the manufacturer must ensure compliance of the final product to the
European harmonized EMC and low-voltage/safety standards. A Declaration of Conformity must be issued for each
of these standards and kept on file as described in Annex II of the R&TTE Directive. Furthermore, the
manufacturer must maintain a copy of the T24 device user manual documentation and ensure the final product
does not exceed the specified power ratings, antenna specifications, and/or installation requirements as
specified in the user manual. If any of these specifications are exceeded in the final product, a submission must
be made to a notified body for compliance testing to all required standards.
OEM Labelling Requirements
The 'CE' marking must be affixed to a visible location on the OEM product.
The CE mark shall consist of the initials "CE" taking the following form:
If the CE marking is reduced or enlarged, the proportions given in the above graduated drawing must be
respected.
The CE marking must have a height of at least 5mm except where this is not possible on account of the
nature of the apparatus.
The CE marking must be affixed visibly, legibly, and indelibly.
Mantracourt Electronics Limited T24 Technical Manual
96
Advertisement
Table of Contents
