Table of Contents
Advertisement
Communications
To configure the base station you will use the Read and Write mechanisms described in the Data Packet
Structures section to read and write parameters and execute commands.
The base station may also be receiving packets from other devices. These will be Data Provider Packets and these
may arrive at any time.
Parameter List
Parameter
Command
Number
ID
Channel
EncKey
UseCSMA
Power
Name
WakerDuration
Save
Reset
NOTE: All changes require a SAVE command to enable them to survive through power cycle or RESET command.
Mantracourt Electronics Limited T24 Technical Manual
3
Read the unique identifier ID for this device. (3 bytes)
11
The radio channel to operate on. (1-16) Requires
power cycle or Reset to enable.
15
The radio encryption key to operate on. Requires
power cycle or Reset to enable. (16 bytes)
supported in this release.
Select whether to use Carrier Sense Multiple Access
18
techniques on transmission.
Value
Description
0
Disabled
The Carrier Sense Multiple Access will be
disabled.
1
Enabled
The Carrier Sense Multiple Access will be
enabled.
See Unslotted CSMA/CA in Appendix A
12
Set or read the output power level. (0-100%)
10
Set or read a user defined name. (11 characters)
17
Set or read the duration in milliseconds to wait for a
device to wake. Although WAKE commands are sent to
the target device the base station actually intercepts
this and handles the wake itself. Default = 12000
milliseconds.
24
Save any changes made to parameters. Required
before power cycling or issuing a Reset command.
Requires 200mS recovery time after executing.
25
Restarts the device and utilises new channel and
encryption keys if those have been changed and saved.
Note after a Reset the device will be asleep.
Description
NOT RECOMMENDED
Native Data
Type
BINARY 3
byte
UINT8
BINARY 16
Not
bytes
UINT8
UINT8
STRING 11
bytes
UINT16
Command
Command
Read /
Write
R
RW
RW
RW
RW
RW
RW
20
Advertisement
Table of Contents
