Result Mode - Mantracourt T24-BSi Technical Manual

Result Mode

OpMode = 1.
Up to 12 individual devices can be summed and the result displayed.
If DoSleepWake is set then the handheld will wake all configured devices when turned on and send them to sleep
again when turned off. NOTE: When the handheld wakes devices this achieved through the transmission of a
broadcast wake. i.e. all devices on the same channel and with the same encryption key will wake.
In this mode there is an option of retrieving a system zero value from an external source. This is activated by
supplying the Data Tag to the ExtZeroDataTag parameter. When activated the value supplied by the Data
Provider packet marked with this tag will be used as the system zero and will be subtracted from the sum of all
contributing inputs.
Usually in this mode only the result is displayed (In the initial devices the result will just be the sum) but by
holding the Next key for 65 seconds will activate the ability to step through each contributing input using the
Next key. See AllowNext
Key Operation when viewing the sum
Key Operation
Sleep No effect
Wake Will attempt to wake any sleeping devices.
Tare Toggle between displaying gross sum or tared sum.
Next No effect unless held for 5 seconds to activate individual item view. This can be disabled by
setting NoNext parameter.
F1 If motion detection is activated then the reading must be steady to enable this key. Pressing this
key with an unstable reading will do nothing.
This transmits a Data Provider packet marked with a Data Tag held in F1DataTag and can also
contain data as defined by F1Data.
Power Toggles between on and off. Hold for 2 seconds to activate.
Key Operation when viewing an individual item
Key Operation
Sleep No effect
Wake Will attempt to wake any sleeping devices.
Tare If sum was currently tared then this key will toggle between displaying gross or tared value of
current device. If sum view was displaying gross then this key has no effect.
If an external system zero is used then only gross values actually supplied to the handheld can be
displayed.
Next Selects next device to view.
F1 If motion detection is activated then the reading must be steady to enable this key. Pressing this
key with an unstable reading will do nothing.
This transmits a Data Provider packet marked with a Data Tag held in F1DataTag and can also
contain data as defined by F1Data.
Power Toggles between on and off. Hold for 2 seconds to activate.
Communications
To configure the device you will use the Read and Write mechanisms described in the Data Packet Structures
section to read and write parameters and execute commands.
Mantracourt Electronics Limited T24 Technical Manual
50