Tokens - Mantracourt T24-BSi Technical Manual

NOTE: All changes require a SAVE command to enable them to survive through power cycle or RESET command.

Tokens

The following tokens can be inserted into the Line1 to Line20 parameters and are decoded when a 'Print' output
is triggered. Tokens are enclosed in triangular brackets.
Token Function
<V1> ... <V8> Substitutes token with the last value received from the input. This
will already have system zero subtracted (If a DoSysZero command
has been issued.) and tare subtracted. (If a DoTare command has
been issued or the switch input has executed a tare.)
<GV1> ... <GV8> Substitutes token with the last value received from the input. This
will already have system zero subtracted (If a DoSysZero command
has been issued.) but no tare subtracted. i.e. it will always contain
the Gross value of the specified input.
<RV1> ... <RV8> Substitutes token with the last value received from the input. This
will NOT have system zero or tare values subtracted.
<TV> Substitutes token with the value carried in the Data Provider packet
that has triggered the 'Print'.
<LOG> Substitutes token with the log value. Each time a 'Print' occurs the
log number will be incremented.
<G> Substitutes token with the Gross sum of all active inputs. System
zero values will have been extracted.
<N> Substitutes token with the Net sum of all active inputs. System
zeros will have been subtracted and also if a Tare has been issued
then the tare value will be extracted.
<EZ> Substitutes token with the External System Zero.
<GN> Substitutes token with the GrossText or NetText parameter contents
depending on the NetMode.
<xx> Substitutes token with the ASCII character whose ASCII value is xx
where xx is a two digit hexadecimal value. i.e. <0D>
Below are listed some useful hex codes.
Hex Value Description
Token
<0D> Carriage Return
<0A> Line Feed
<09> Tab
<1B> Escape
Configuration Examples
LED Display From a Single Source
We want to put data from a T24-SA onto a large LED display.
We will use the out of the box rate of 3 per second. The display only needs the ASCII data followed by a carriage
return.
Mantracourt Electronics Limited T24 Technical Manual
This is useful when there is only one input and that input is
used to trigger the 'Print' output. Without this parameter
being set a loss of the data would not trigger the 'Print'.
With this set, once the data is lost the output will be
triggered and any reference to the input value would
appear as ------.
Value Description
0 Do not trigger a 'Print' when loss of
data/communications occur.
1 Trigger a 'Print' when loss of
data/communications occur.
Example
1.2345
1.2345
1.2345
1.2345
0003
1.2345
1.2345
1.2345
Gross
ÆӪ-ü▀
62