Table of Contents
Advertisement
Parameter List
Parameter
ID
Version
Channel
EncKey
Power
Name
Model
UseCSMA
OffDelay
AutoZero
DoSleepWake
Timeout
KeepAwakeInt
DisplayUpdate
PairWait
Format
ZeroSupp
51
Mantracourt Electronics Limited T24 Technical Manual
Command
Description
Number
3
Read the unique identifier ID for this device. (3 bytes)
53
Read the firmware version.
11
Radio Channel
15
The radio encryption key to operate on. Requires
power cycle or Reset to enable.
release.
12
Set or read the output power level. (0-100%)
10
Set or read a user defined name. (11 characters)
51
Read the model number of the device.
Select whether to use Carrier Sense Multiple Access
18
techniques on transmission.
Value
0
1
See Unslotted CSMA/CA in Appendix A
62
Time period in seconds before switching off if no
button is pressed. Setting to zero disables. Default = 5
63
Set or read the value limit which may be automatically
zeroed on startup.
When the handheld powers up and the input value is
within ±ZeroBand then the display will be zeroed. The
value of the input will be placed in AutoZero. i.e. from
this time onwards until powered off the display will
show
input value - AutoZero
64
Set or read whether to perform wake and sleep on the
paired device when the handheld is powered up and
down. Default = 1
65
Set or read the time in seconds that if exceeded
between receiving Data Provider packets from the
paired device will cause the display to show ------.
Default = 3
66
Set or read the interval in seconds between the
handheld transmitting StayAwake signals to the paired
device. Default = 5
74
Set or read the interval between LCD updates. Default
= 300
67
Set or read the period in seconds that the handheld
will wait for another device to pair when placed into
pair mode. Default = 5
70
Set or read the format for the display. Here you can
define how the value will be displayed and where the
decimal point will appear. By including a non zero
value this will define the resolution of the displayed
value. i.e. the smallest step size of value changes.
Default = 0000.001
71
Set or read whether to show the value on the display
with zero suppression.
0 = No zero suppression
1 = Zero suppression
Not supported in this
Description
Disabled
The Carrier Sense Multiple Access will be
disabled.
NOT RECOMMENDED
Enabled
The Carrier Sense Multiple Access will be
enabled.
Native
Read /
Data
Write
Type
BINARY 3
R
bytes
FLOAT
R
UINT8
RW
BINARY
RW
16 Bytes
UINT8
RW
STRING
RW
11 Bytes
STRING
R
11 Bytes
UINT8
RW
UINT16
RW
FLOAT
RW
UINT8
RW
UINT16
RW
UINT16
RW
UINT16
RW
UINT8
RW
STRING 8
RW
bytes
UINT8
RW
Advertisement
Table of Contents
