Data Provider Format - Mantracourt T24-BSi Technical Manual

UnitsSelection
Value
Offset
DigitalOut
Status
Reset
Save
Wake
Sleep
Pause
Resume
StayAwake
SleepTrigger
PauseTrigger
ResumeTrigger
StayAwakeTrigger
NOTE: All changes require a SAVE command to enable them to survive through power cycle or RESET command.

Data Provider Format

At every TXInterval a Data Provider packet is transmitted that holds 1 value in FLOAT format (See Appendix A).
Mantracourt Electronics Limited T24 Technical Manual
79 Select the units for the output.
Value
0
1
2
3
72 Reads the user calibrated output.
107 Set an offset to be subtracted from the final value.
108 Read or set the digital output state.
Value
0
1
2
74 Live status where the bit values indicate status. The
following table shows the decimal bit values and their
meaning.
Bit Value
1
2
4
8
16
32
64
128
54 Restarts the device and utilises new channel and
encryption keys if those have been changed and saved.
55 Save any changes made to parameters. Required
before power cycling or issuing a Reset command.
Requires 500mS recovery time after executing.
50 Wake the module from sleep
56 Sends the module to Sleep
57 Stops the output streaming to allow configuration
59 Streaming continues.
58 No function other than to reset SleepDelay timer
120 Enter Data Tag to watch for that will trigger sleep
mode
121 Enter Data Tag to watch for that will trigger pause
mode
123 Enter Data Tag to watch for that will trigger resume
mode
122 Enter Data Tag to watch for that will reset SleepDelay
timer.
Definition
°
C Degrees Celcius
°
F Degrees Farenheight
°
K Degrees Kelvin
R Ohms
Definition
Turn digital output off
Turn digital output on
Make digital output mirror the LED
state (V1.05 and later)
Definition
STATUS_SHUNT_CAL
STATUS_INPUT_INTEGRITY
Reserved
Reserved
STATUS_POWER_UP
STATUS_BATT_LOW
STATUS_DIGITAL_INPUT
STATUS_DIGITAL_OUTPUT
UINT8 RW
FLOAT R
FLOAT RW
FLOAT RW
Command
Command
Command
Command
Command
Command
Command
UINT16 RW
UINT16 RW
UINT16 RW
UINT16 RW
44