Table of Contents
Advertisement
Reset
Save
Wake
Sleep
Pause
Resume
StayAwake
SleepTrigger
PauseTrigger
ResumeTrigger
StayAwakeTrigger
DoSystemZeroTrigger
NOTE: All changes require a SAVE command to enable them to survive through power cycle or RESET command.
Data Provider Format
Ten readings are contained in each Data Provider packet and these are transmitted every 5mS (200 packets per
second). Also in each packet there is a 16bit timestamp which indicates when the first data value was added to
the packet where each unit equates to 500uS. Using this timestamp it is possible to reconstruct data even with
missing packets. Note that the timestamp will restart from zero every 32.768 seconds.
The Data Provider packet is typed as Binary. The 10 readings are next, each formatted as an INT32 (See Appendix
A) and these are followed by the timestamp formatted as a UINT16.
Mantracourt Electronics Limited T24 Technical Manual
Bit Value
1
2
4
8
16
32
64
128
54
Restarts the device and utilises new channel and
encryption keys if those have been changed and saved.
55
Save any changes made to parameters. Required
before power cycling or issuing a Reset command.
Requires 500mS recovery time after executing.
50
Wake the module from sleep
56
Sends the module to Sleep
57
Stops the output streaming to allow configuration
59
Streaming continues.
58
No function other than to reset SleepDelay timer
120
Enter Data Tag to watch for that will trigger sleep
mode
121
Enter Data Tag to watch for that will trigger pause
mode
123
Enter Data Tag to watch for that will trigger resume
mode
122
Enter Data Tag to watch for that will reset SleepDelay
timer.
125
Enter Data Tag to watch for that will reset SleepDelay
timer.
Definition
STATUS_SHUNT_CAL
STATUS_INPUT_INTEGRITY
Reserved
Reserved
STATUS_POWER_UP
STATUS_BATT_LOW
STATUS_DIGITAL_INPUT
STATUS_DIGITAL_OUTPUT
Command
Command
Command
Command
Command
Command
Command
UINT16
RW
UINT16
RW
UINT16
RW
UINT16
RW
UINT16
RW
34
Advertisement
Table of Contents
