Table of Contents
Advertisement
AllowSysZero
Reset
Save
DoSysZero
RmSysZero
NOTE: All changes require a SAVE command to enable them to survive through power cycle or RESET command.
Power Supply
Recommend using alkaline AA cells as rechargeable are too low voltage and lithium may not be able to supply the
current for the radio to start up.
Installation
There are no specific installation instructions.
Mantracourt Electronics Limited T24 Technical Manual
the number of seconds to hold down the Next key to
activate this feature. Once activated the Next key
steps through all input values.
Once the device is powered off this feature would
have to be activated again.
( range:0 to 30 default:6 )
130
Determines whether to allow the ability to perform
system zero by pressing and holding the Tare key.
Set to zero to disable or set to a number representing
the number of seconds to hold down the Tare key to
perform the system zero.
( range:0 to 30 default:12 )
54
Restarts the device and utilises new channel and
encryption keys if those have been changed and saved.
55
Save any changes made to parameters. Required
before power cycling or issuing a Reset command.
Requires 500mS recovery time after executing.
120
Perform a system zero on all devices. This will remove
the current input values so from this point on the
current input will give a value of zero. This can be
removed by issuing the RmSysZero command.
121
Reset the system zero settings so values will represent
the actual inputs.
UINT8
RW
Command
Command
Command
Command
54
Advertisement
Table of Contents
