Fitting the towing eye
– Take the towing ring from the on-board tool set.
– Remove the front cover by pressing down on its left-hand side.
– Remove the rear cover by pressing down on the right hand side,
for FR and Cupra models. For all other versions, remove the rear
cover by pressing on the lower part.
– Screw the towing eye as shown by the arrow anti-clockwise to the
limit position in the front
⇒ page 268, fig. 182
Safety first
⇒ page 268, fig. 181
or rear
threaded hole.
Operating instructions
Practical tips
If and when
Technical data
269