Seat Leon 2010 Owner's Manual page 128

126 Lights and visibility
•
The next speed down will automatically be selected if wiper speed
⇒ page 124, fig. 80 A
or
3
will be resumed when the vehicle starts again
•
The windscreen will be wiped again after approximately five seconds once
the "automatic wipe/wash system" has been operated, provided the vehicle
is in transit (drip function). If you activate the wipers less than three seconds
after the drip function, a new wash sequence will begin without the last wipe.
For the "drip" function to work again, you have to turn the ignition off and
then on again.
•
When the "intermittent wipe function" is on, the intervals are directly
proportional to the speed. This way, the higher the vehicle speed the shorter
the intervals.
•
The wiper will try to wipe away any obstacles that are on the windscreen.
The wiper will stop moving if the obstacle blocks its path. Remove the
obstacle and switch the wiper back on again.
•
Before removing any objects that may be trapped in the side areas of the
windscreen, always move the wiper arms to the service position (horizontal).
•
The heat output of the heated jets is controlled automatically when the
ignition is switched on, depending upon the outside temperature.
is selected when the vehicle stops. The set speed
A
Rain sensor*
2
The rain sensor controls the frequency of the windscreen
wiper intervals, depending on the amount of rain.
Fig. 81 Rain sensor*
Fig. 82 Windscreen wiper
lever