Tyre repair
The following sections describe the procedures for repairing
a tyre.
Using the sealing compound
– The instructions on the container give detailed information on
how to use the sealing compound.
Inflating the tyre.
– Remove the air compressor and hose from the container.
– Screw the retaining nut onto the valve.
– Plug the compressor cable into a 12 volt power point.
– Turn on compressor and monitor the pressure shown on the pres-
sure gauge.
Completing the repair
– Remove the compressor hose from the valve.
– Fit the valve cap.
– Unplug the compressor from the socket.
– Return all tools to their proper storing location.
Note
•
If the vehicle is equipped with tyre pressure control, enter the new tyre
pressures using the SET button on the centre console.
•
The compressor should never be allowed to run for longer than 6
minutes.
Safety first
Operating instructions
Fuses
Changing a fuse
Blown fuses must be replaced
Practical tips
If and when
Fig. 160 Left side of dash
panel: Fuse box cover
Fig. 161 Fuse box cover
in engine compartment
Technical data
251