ABB ACS880-37 Hardware Manual page 19

Support the top and
bottom of the module
when extracting it from the
cubicle!
50...150 mm max.
Lift the module by the upper part
only using the lifting eyes at the
top!
•
Beware of hot surfaces. Some parts, such as heatsinks of power semiconductors,
remain hot for a while after disconnection of the electrical supply.
•
Keep the drive in its package or protect it otherwise from dust and burr from drilling
and grinding until you install it. Protect also the installed drive against dust and burr.
Electrically conductive debris inside the drive can cause damage or malfunction.
•
Vacuum clean the area below the drive before the start-up to prevent the drive cooling
fan from drawing the dust inside the drive.
•
Do not cover the air inlet and outlet when the drive is running.
•
Make sure that there is sufficient cooling. See section
(page 57).
•
Before you connect voltage to the drive, make sure that the cabinet doors are closed.
Keep the doors closed during operation.
Do not tilt!
Mind your fingers! Keep fingers
away from the edges of the front
flange of the module!
Safety instructions 19
Do not leave the module
unattended on a sloping floor!
Support the top and bottom
of the module when
reinserting it into the cubicle!
Examining the installation site