Dynatronics dynatron solaris 709 plus Service Manual page 109

dynaTron® TherMosTIM™ Probe
8. Saving Custom Default Parameters or Treatment Setups
After completing the treatment setup or after choosing new default parameters – but before pressing START to begin
a treatment, PRESS and HOLD the START key until a tone sounds. The tone indicates that new Default settings have
been saved, or that the ThermoStim treatment parameters are saved for future use.
Dynatron ThermoStim Specifications
Power Requirements ...............................................................................................................None
Power Consumption ................................................................................................................None
Fuse ............................................................................................................................................None
Dimensions ......................................................................................... 2" (W) x 3.6" (D) x 10" (L)
Weight ...................................................................26.455 ounces or .1.653 pounds (750 grams)
WHEN TREATING WITH THE THERMOSTIM PROBE, FOLLOW ALL CONTRAINDICATIONS, WARNINGS,
AND PRECAUTIONS ASSOCIATED WITH THE ELECTRICAL STIMULATION TREATMENT USED IN
COMBINATION WITH HEAT OR COLD.
THERE ARE NO SERVICEABLE PARTS INSIDE THE DYNATRON THERMOSTIM PROBE.
DYNATRON SOLARIS PLUS SERIES | SERVICE MANUAL REV. 6
®
5.08 cm (W) x 9.14 cm (D) x 25.4cm (L)
WARNING
CAUTION
| AUGUST 29, 2017 101