Configuring Ports (Gui) - Cisco WLC 5700 Series Interface Configuration Manual

Configuring Interfaces
Parameter
Interface Type
Interface Name
IP Address
IP Netmask
MAC Address
VLAN ID

Configuring Ports (GUI)

You can configure ports in controller using the web UI. To do this, you must follow the steps defined in this
module in the web UI.
You can create the following types of port using the controller web UI.
• Loopback Interfaces
• EtherChannel Port
• Ten Gigabit Ethernet Interfaces
• Gigabit Ethernet Interfaces
SUMMARY STEPS
1. Choose Configuration > Controller > System > Interfaces > Port Summary.
2. Click on the port in the port summary table to view the details of the selected port.
3. Click Apply.
OL-32314-01
Description
Displays the operator-defined interface type. Values are as follows:
• Static—Wireless Management.
• AP-Manager.
• Service-Port—The Ten Gigabit Ethernet port located on the back of the controller
• Virtual interfaces.
Displays the name of the interface. Values are as follows:
• Management—802.11 distribution system wired network.
• Service-port—System service interface.
• Virtual—Loopback interface for the web interface to work. This is available in
the controller by default. You need not explicitly configure this interface.
• AP-manager—Can be on the same subnet as the management IP address, but
must have a different IP address than the management interface.
• name—Operator-defined interface assignment, without any spaces.
Displays the IP address of the Controller and its distribution port.
Displays the destination subnet mask.
Displays the MAC address of the interface.
Displays the virtual LAN assignment of the interface.
Interface Configuration Guide, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
Configuring Ports (GUI)
41